Table of Contents
Advertisement
4.
Wait until normal monitoring screen appears, then check that the picture on the screen is
displayed with correct resolution.
If the resolution is not correct, replace the remote controller cable.
?
5.
Enter the service menu:
Menu
(on the remote controller keypad)
4-34) - Service (password 26-23-8)
Take down the information regarding remote controller software.
?
Select the menu KEYBOARD:
•
Service - Keyboard
6.
Check the remote controller keys.
Press the keys one by one. Check that each key generates a sound from the loudspeaker.
?
7.
Check the ComWheel.
Turn the ComWheel clockwise and counterclockwise and check that each step generates a
sound and the corresponding values at the bottom of the menu increase.
Select DUMMY PRESS. Press the ComWheel and check that the press generates a sound and
the corresponding value in the menu increases.
?
8.
Perform electrical safety check and leakage current test.
?
9.
Check that the remote controller functions normally after the performed electrical safety
check.
?
10. Clean the remote controller and the cable.
?
Fill in all necessary documents.
•
Command Boards / Bars, Remote Controller
- Monitor Setup
- Install/Service (password 16-
9
Document No. 8001589 -1
Advertisement
Table of Contents
