Anova FBW6R Assembly Instructions

anovafurnishings.com
888.535.5005 tel

tools needed:

• 1/2" Open-end or Box-end Wrench
• 5/16" Open-end or Box-end Wrench
• Ratchet with 1/2" Socket
• Ratchet with 5/16" Socket
• Square

Assembly hArdWAre:

4 x
No. 12 X 1.5"
Pan Head Screw

Assembly:

1. Inspect the shipping container contents for damage and to
determine that all components and hardware are present.
2. Assemble the bench over the packaging cardboard or padded
work bench to avoid scratching the product.
3. Layout the Planks on the work area with the predrilled holes
facing upward.
NOTE: Two of the Planks have two extra holes toward one end. These
Planks must be placed in the center of the bench with the
additional holes located near the bench centerline. The additional
holes are placed to mount the Gusset Brackets.
4. Place the Cross Support across the center of the Planks and line
up the holes in the Cross Support with the predrilled holes in the
middle of the Planks. Start a 5/16" Lag Screw into each of the
Bench Support holes, except for the two center mounting holes.
These two holes will be used to fasten the Bench Channel.
5. Before tightening the Lag Screws, place the "L"-shaped Bench
Brackets across the planks with the raised edge facing outward at
each end of the Planks. Start a 5/16" Lag Screw through each of
the holes in the Brackets into the predrilled holes in the Planks.
After all 18 of the Lag Screws have been started, use the 1/2"
Socket to tighten them down.
ASI 274-F S529_HRD103
Assembly InstructIons
FbW6r 6 ft Parkway Recycled Plastic Flat Bench

bench components:

2 x Center Plank
Recycled Plastic
2 x Cast Iron Bench Leg
6 x 12 x
5/16" X 1.25" 5/16"
Hex Head Bolt Washer
4 x Outer Plank
Recycled Plastic
2 x Bench Bracket 1 x Cross Support
4 x 18 x
5/16" 5/16" X 2.0"
Flanged Hex Nut Lag Screw
IMPORTANT:
Note location and orientation of
Gusset Brace mounting holes
5/16" Lag Screws
1 x Bench Channel
2 x Gusset Bracket
Packaging cardboard or
other soft work surface
Leave the two center
holes empty