Anova F1030 Assembly Instructions

anovafurnishings.com
888.535.5005 tel

tools needed:

• 1/2" Open-end or Box-end Wrench
• Ratchet with 1/2" Socket
• Rubber Mallet
• Level

Assembly HArdwAre:

24 x
12 x
5/16"
5/16" X 1.25"
Washer
Hex Head Bolt

Assembly:

The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
2. Place the Bench Seat upside down on the shipping
packaging or other soft surface to avoid scratching the
product. Locate one of the Bench Supports and position
it near the end of the Seat.
3. Align the mounting holes in the Support Bracket with
the mounting holes in the end of the Bench Seat. Install
a Washer onto one of the provided Bolts and insert
the Bolt through both parts, with the Bolt head on the
outside surface of the Bench Seat. Install a Washer and
Flanged Nut on the inside end of the Bolt.
NOTE: Installing the Bolt in this direction reduces the risk of
scratching during use.
Leave the hardware finger tight so that adjustments can
be made during assembly and leveling.
Install a Bolt and Washer through the other set of
mounting holes in that end of the Bench Seat and
Support Bracket and install a Washer and Flanged Nut.
Again, leave the hardware finger tight.
4. Attach the other Bench Support to the Bench Seat
in the same manner, installing the Bolts from the
outside inward. Leave the hardware finger tight.
Assembly InstructIons
F1030 4 ft Courtyard Bench
F1034 6 ft Courtyard Bench
bencH components:
12 x 4 x
5/16" Rubber Foot
Flanged Hex Nut
1 x 2 x
Bench Seat Bench Support
Washer and
Flanged Nut
2 x 2 x
Cross Brace Arm Rest
Support
Bracket
Washer
Bolt
Washer
Flanged
Nut
Bench
Seat
packaging cardboard or
other soft surface
Washer
and Bolt