Suzuki Burgman Series Owner's Manual page 96

9. Replace the drain plug gasket
3 with a new one. Reinstall
the drain plug 2 and gasket
3. Tighten the plug securely
with a torque wrench. Pour
2900 ml (3.1 US qt) of new oil
through the filler hole and
install the filler cap. Be sure to
always use
engine oil described in the
FUEL, ENGINE
COOLANT
TIONS section.
Drain plug tightening torque:
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
NOTE: About 2600 ml (2.7 US qt)
of oil will be required when chang-
ing oil only.
NOTICE
Engine damage may occur if
you use oil that does not meet
Suzuki's specifications.
Be sure to use the oil specified
in the FUEL, ENGINE OIL AND
COOLANT
TIONS section.
the specified
OIL AND
RECOMMENDA-
RECOMMENDA-
10.Start the engine (while the
motorcycle is outside on level
ground) and allow it to idle for
three minutes.
11.Turn the engine off and wait
approximately three minutes.
Recheck the oil level on the
engine oil inspection window
while holding the motorcycle
vertically. If it is lower than the
"L" line, add oil until the oil level
is between the "L" line and the
"F" line. Inspect the area
around the drain plug and oil
filter for leaks.
NOTE: If you do not have a proper
oil filter wrench, have your Suzuki
dealer perform this service.
7-25