Autopark - Chrysler Pacifica 2021 Owner's Manual

146 STARTING AND OPERATING
ENGINE START/STOP Button Functions — With
Driver's Foot OFF The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates
similar to an ignition switch. It has three
positions; OFF, ACC, and RUN. To change the
ignition positions without starting the vehicle
and to use the accessories follow these steps:
Start with the ignition in the OFF position.

Push the ENGINE START/STOP button once

to place the ignition to the ACC position
(instrument cluster will display "ACC").
Push the ENGINE START/STOP button a second

time to place the ignition to the RUN position
(instrument cluster will display "ON/RUN").
Push the ENGINE START/STOP button a third

time to return the ignition to the OFF position
(instrument cluster will display "OFF").
NOTE:
Only press one pedal at a time while driving the
vehicle. Torque performance of the vehicle
could be reduced if both pedals are pressed at
the same time. If pressure is detected on both
pedals simultaneously, a warning message will
display in the instrument cluster Ú page 121.
A P
UTO ARK
AutoPark is a supplemental feature to assist in
placing the vehicle in PARK if the situations
below occur. It is a back up system and should
not be relied upon as the primary method by
which the driver shifts the vehicle into PARK.
The conditions under which AutoPark will
engage are outlined on the following pages.
WARNING!
Driver inattention could lead to failure to

place the vehicle in PARK. ALWAYS DO A
VISUAL CHECK that your vehicle is in PARK
by verifying that a solid (not blinking) "P" is
indicated in the instrument cluster display
and near the gear selector. If the "P" indi-
cator is blinking, your vehicle is not in PARK.
As an added precaution, always apply the
parking brake when exiting the vehicle.
AutoPark is a supplemental feature. It is not

designed to replace the need to shift your
vehicle into PARK. It is a back up system
and should not be relied upon as the
primary method by which the driver shifts
the vehicle into PARK.
ALWAYS DO A VISUAL CHECK that your vehicle
is in PARK by looking for the "P" in the
instrument cluster display and on the gear
selector. As an added precaution, always apply
the parking brake.
If the vehicle is not in PARK and the driver
attempts to turn off the engine, if certain
conditions are met, the vehicle will AutoPark,
automatically shifting the vehicle's
transmission to the PARK position. The gear
selector will automatically reset itself to the
PARK position. The vehicle's ignition will then
move to the OFF position (engine off). When
AutoPark is activated the instrument cluster will
display the message "AutoPark Engaged".
AutoPark will engage when all of these
conditions are met:
Vehicle is equipped with a gear selector

Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Driver has pushed the ENGINE START/STOP

button