Autopark - Chrysler PACIFICA HYBRID 2023 Manual

4. Push the ENGINE START/STOP button a third time,
without brake pedal being pressed, to return the
ignition to the OFF position (instrument cluster will
display "OFF").
NOTE:
Only press one pedal at a time while driving the vehicle.
Torque performance of the vehicle could be reduced if
both pedals are pressed at the same time. If pressure is
detected on both pedals simultaneously, a warning
message will display in the instrument cluster.
A P
UTO ARK
AutoPark is a supplemental feature to assist with placing
the vehicle in PARK should the situations on the following
pages occur. It is a back-up system and should not be
relied upon as the primary method by which the driver
shifts the vehicle into PARK.
The conditions under which AutoPark will engage are
outlined on the following pages.
WARNING!
 Driver inattention could lead to failure to place the
vehicle in PARK. ALWAYS DO A VISUAL CHECK that
your vehicle is in PARK by verifying that a solid (not
blinking) "P" is indicated in the instrument cluster
display and near the gear selector. If the "P" indicator
is blinking, your vehicle is not in PARK. As an added
precaution, always apply the parking brake when
exiting the vehicle.
 AutoPark is a supplemental feature. It is not
designed to replace the need to shift your vehicle
into PARK. It is a back-up system and should not be
relied upon as the primary method by which the
driver shifts the vehicle into PARK.
ALWAYS DO A VISUAL CHECK that your vehicle is in PARK
by looking for the "P" in the instrument cluster display and
on the gear selector. As an added precaution, always apply
the parking brake.
If the vehicle is not in PARK and the driver attempts to turn
off the engine, if certain conditions are met, the vehicle
will AutoPark, automatically shifting the vehicle's
transmission to the PARK position. The rotary shifter will
automatically reset itself to the PARK position. The
vehicle's ignition will then move to the OFF position
(Engine off). When AutoPark is activated the instrument
cluster will display the message "AutoPark Engaged".
AutoPark will engage when all of these conditions are met:
 Vehicle is equipped with a gear selector
 Vehicle is not in PARK
 Vehicle speed is 1.2 mph (1.9 km/h) or less
 Driver has pushed the ENGINE START/STOP button
(Continued)
If the vehicle is not in PARK and the driver exits the vehicle
WARNING!
with the engine running, if certain conditions are met, the
vehicle will AutoPark, automatically shifting the vehicle's
transmission to the PARK position. The Electric Park Brake
SAFE HOLD feature will also activate in some conditions.
Refer to "Parking Brake" in "Starting And Operating" in
your Owner's Manual for further information.
AutoPark will engage when all of these conditions are met:
 Vehicle is equipped with a gear selector
 Vehicle is not in PARK
 Vehicle speed is 1.2 mph (1.9 km/h) or less
 Driver's door is ajar
 Driver's seat belt is unbuckled
 Brake pedal is not pressed
The message "AutoPark Engaged" will display in the
instrument cluster.
AutoPark In Stop/Start Autostop Mode
AutoPark will engage when all of these conditions are met:
 Vehicle is equipped with a gear selector
 Vehicle is not in PARK
 Vehicle speed is 1.2 mph (1.9 km/h) or less
 Driver's door is ajar
 Driver's seat belt is unbuckled or brake pedal is not
STARTING AND OPERATING
CAUTION!
Engine will remain running.
pressed
39
4