Axis 5600+ User Manual page 32

32
Performing a factory Follow the instructions below to reset the AXIS 5600+ to the factory
default default settings. Please note that a factory default should be
performed with caution!
All parameters except Node Address (NODE_ADDR), Internet Address
(IP_ADDR) and DHCP enabled or disabled (DHCP_ENABLE.) will be
reset.
1. Remove the Power Adapter to switch off the AXIS 5600+
2. Remove the network cable.
3. Press and hold down the test button while you plug the Power
Adapter back in. Continue to hold down the test button until the
network indicator begins to flash at one-second intervals. This
should take about 5 seconds.
4. Release the test button and wait until the network indicator flashes
at least five times.
5. Press and hold down the test button again until the network
indicator remains constantly lit.
6. Disconnect the Power Adapter.
7. Insert the network cable.
8. Restart the AXIS 5600+ by reconnecting the Power Adapter.
AXIS 5600+ User's Manual