Axis 5600+ User Manual page 31

AXIS 5600+ User's Manual
Setting the print
server's IP adderss
using BOOTP
in UNIX
Notes:
Follow the instructions below to set the IP address using BOOTP:
1. Append the following entry to your boot table. This is typically
performed by editing the file:
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<IP address>:\
:sm=<subnet mask>:gw=<gateway field>
Example:
npsname:ht=ether:vm=rfc1048:\
:ha=00408c100086:ip=192.168.3.191:\
:sm=255.255.255.0:gw=192.168.1.1
Enter the and fields exactly as shown in the example.
ht vm
The field is the Ethernet address/node address and the
ha
the IP address of your AXIS 5600+.
The and fields correspond to the default router address and
gw sm
subnet mask.
If the host name has not been mapped to an IP address, simply
replace the host name entry with the IP address in the example
above.
2. If necessary, update your host table and alias name databases, as
required by your system.
3. If it is not already running, start the BOOTP daemon. This is typically
performed using the
4. Restart the AXIS 5600+ to download the IP address, default router
address, and subnet mask.
The AXIS 5600+ can automatically download a customized config file
from a TFTP server. Just add the name of the config file and the TFTP
server's IP address to your boot table. The config file is downloaded
immediately after the AXIS 5600+ receives its IP address.
/etc/bootptab
command.
bootpd
31
field is
ip