AXIS 242S IV - Product description
6
Front panel
Video output
S-Video (Y/C) input
Video input
Control button
Mic In & Line In
DSP & IV LED indicators
LED indicators for Network, Status & Power
DIP switch
Mic In & Line In - 2 separate inputs for Line In and Mic In, respectively. Note that these
inputs are used for internal audio analysis only.
Video Input - The video input uses a coax/BNC connector. Physical connections made
using 75 ohm coaxial video cable have a recommended maximum length of 800 feet (250
meters).
S-Video (Y/C) input - For direct connection of a Y/C video source.
Video Output - Video for debugging purposes is available on this output when the Digital
Signal Processor (DSP) is running an Intelligent Video module.
Control Button - Press this button to restore the factory default settings, as described in
Resetting to the factory default settings, on page 48, or to install using AXIS Internet
Dynamic DNS Service (See the Axis Video Server Installation Guide).
LED indicators - See page 8.
DIP switch - The DIP switch is for line termination of the video input. Slide the switch to
the right to enable.