Resetting To The Factory Default Settings; More Information - Axis 221 Installation Manual

Page 10
Accessing the AXIS 221 from the Internet
Once installed, your AXIS 221 is accessible on your local network (LAN). To access the camera
from the Internet, network routers must be configured to allow incoming traffic, which is
usually done on a specific port. Please refer to the documentation for your router for further
instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Reset button (rear panel) and reconnect power.
3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15
seconds), then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the camera is
reset to the factory default settings.
5. Re-install the AXIS 221 using one of the methods described in this document.

More information

For more information, please see the AXIS 221 User's Manual, which is available on the CD
included in this package. Updated versions can be obtained from www.axis.com
AXIS 221 Installation Guide