Power Cord Requirements For Ac-Powered Switches And Ac Power Supplies - Extreme Networks ExtremeRouting SLX 9740 Hardware Installation Manual

Power Cord Requirements for AC-Powered Switches
and AC Power Supplies
Table 33: Power Specifications (AC Power Supplies) (continued)
Power cord wall plug
Power supply cord gauge
Efficiency
Table 34: Power Specifications (DC Power Supplies)
Nominal input
DC Voltage input range
Inrush Current
Maximum wire size
DC Output
Power (W)
Table 35: Environmental Specifications
Operating temperature (front-to-
back airflow)
Operating temperature (back-to-
front airflow)
Storage temperature
Operating humidity
Operational shock
Power Cord Requirements for AC-Powered Switches and AC Power
Supplies
An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
•
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
minimum wire size is 16 AWG (1.0 mm
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/.
88 ExtremeRouting SLX 9740 Hardware Installation Guide
ExtremeRouting SLX 9740 Technical Specifications
Refer to Power Cord Requirements for AC-Powered Switches
and AC Power Supplies on page 88
16 AWG (1.0 mm 2 ) over 6 feet
Low Line: 88% at 50% load and 86% at 100% load
High Line: 90% at 50% and 100% loads
-48 to -60 VDC
+/-39VDC to +/-72VDC, 50A max.
21 A peak
14 AWG (1.5 mm2 copper stranded).
+12.2V/131A, +12Vsb/2.5A
1600 W
0°C to 45°C (normal operation)
0°C to 45°C (normal operation)
-40°C to 70°C
5% to 95% relative humidity, non-condensing
30 m/s 2 (3 G)
2
).
2
) minimum; over 6 feet, the
http://