Led Indicators - Extreme Networks ExtremeRouting SLX 9740 Hardware Installation Manual

Monitoring the Device
Figure 32: SLX 9740 switch router LEDs
1. Power LED
2. Locater LED
3. Status Port LEDs
4. Management port LEDs
5. Console port LEDs

LED indicators

The SLX 9740 switch router LED indicators are as follows:
•
The Power/Status LEDs are visible to the front panel
•
The Ethernet LEDs are integrated with the RJ45 connector
•
The Power supply LEDs are integrated with the PSU
•
The 10G and 100G Port LEDs are surface mount types. They are visible to the front panel
The following table shows the LED indications on the SLX 9740 switch router:
Table 12: SLX 9740 device LED Indications
LED Function/state
Power
Off
Green
Status (bicolor)
Blinking Amber-Green
Amber
Green
Power Supply Output Status (On PSU)
Off
Green Blinking
Green Steady
Meaning
No power
Valid power. All monitored
voltages are nominal
Attention
Fault/ initial state
Board is operational
No Power
Stand-By
Power GOOD
ExtremeRouting SLX 9740 Hardware Installation Guide
LED indicators
Possible cause
Some Power rails are dropping
below specification
TBD by SW
This LED shall be lit during the
reboot
Standby output enabled with no
power supply warning or fault
detected
Main output and standby output
enabled with no power supply
warning or fault detected
65