Extreme Networks ExtremeRouting SLX 9740 Hardware Installation Manual page 71

Removing and Replacing Components
e. Release the tab that holds the front of the slider assembly to the front rack post, and pull the
pegs out.
See the diagram below - Removing the Slider Assembly: Front Rack Post .
Figure 35: Removing the Slider Assembly: Front Rack Post
f. Repeat steps "d" and step "e" to remove the second slider assembly.
4. To remove a device from a two-post rack, do the following:
a. Carefully supporting the weight of the device, unscrew the mounting brackets from the rack.
b. Tilt the device so that the brackets are clear of the rack posts, and carefully lift it out of the rack.
If the device cannot be tilted (because other equipment is mounted directly above and below),
remove one or two mounting brackets from the device and then slide the device out.
If you plan to use the device again later, we recommend storing it with the mounting brackets attached.
ExtremeRouting SLX 9740 Hardware Installation Guide
Removing the Device from the Rack
71