Extreme Networks ExtremeRouting SLX 9740 Hardware Installation Manual page 41

Installing Your Device
3. Attach a long mounting bracket to one side of the switch router housing and to the rack post.
a. Position the long bracket over the holes between the front and the middle of the device. Orient it
so that its flange (ear) rests against the rack post.
See the diagram below: Attaching a Long Mounting Bracket: Middle of Switch Router.
Figure 19: Attaching a Long Mounting Bracket: Middle of Switch Router
b. Use six small mounting screws (provided) to attach the bracket to the device.
c. Secure the long bracket to the rack post.
(Rack-mounting screws are not provided.)
4. Repeat step 3 to attach the other long bracket on the other side of the device.
5. Tilting the device slightly, lift it into the rack so that the mounting brackets align with the rack posts.
If the device cannot be tilted (because other equipment is mounted directly above and below),
remove one or both short mounting brackets from the device. Lift the device into position, secure
the flanges (ears) on the long brackets to the rack posts, and then reattach the short brackets.
Attaching the Device to a Two-Post Rack
ExtremeRouting SLX 9740 Hardware Installation Guide 41