Other Info Pages - Siemens Synco 700 Operating Instructions Manual

Other Info pages

To go to the Info pages:
1. Return to the start page by pressing the ESC button.
2. Press the INFO button.
3. Turn the OK knob until the required page appears.
Time switch
For description of the time switch and its settings, refer
to pages 10 and 11.
Heating circuit
For description of the heating circuit and its settings,
refer to page 8...14. The info pages contain:
• The actual value of the flow temperature
• The flow temperature setpoint
• State
• Cause
• The actual value of the room temperature (only if a
room sensor is used)
• The room temperature setpoint
• The outside temperature (the details given in the
following section "Display values" also apply here!)
Building Technologies / HVAC Products
Display values
(only with RMK770)
The actual outside temperature is displayed provided the
measured value is delivered. Other displays are possible
(depending on the design of your plant).
Fault inputs
(only with RMK770)
Fault status messages at the fault inputs are displayed
only if configured.
Device state
Displays in the event of fault:
• Source of fault (e.g. B1 pump. B1 stands for boiler 1,
B2 for boiler 2, etc.)
• Error code (important for the heating engineer)
• Date and time of day the fault occurred
Fault status message bus
If your plant includes several interconnected devices,
your controller can also display faults of other controllers
(depending on the configuration made).
CE1B3133x2-en 74 319 0560 0 a
29
10.10.2006