Page 3
OBSERVATION OF THE OPERATING INSTRUCTIONS WILL HELP TO AVOID DANGERS, REDUCE REPAIR COSTS AND SHUTDOWN TIMES AND INCREASE THE RELIABILITY AND WORKING LIFE OF THE PRODUCT Warnings and safety instructions for Pentair Aquatic System filters and other related products are available at our website: www.pentairpooleurope.com THIS MANUAL CONTAINS CRITICAL SAFETY INFORMATION THAT MUST BE PROVIDED TO THE END USER.
Page 4
INSTALLATION Install the filter in a dry, well-ventilated location with adequate access for servicing. Place the filter in its permanent location on a completely level base, preferably made of concrete poured as a single slab or on a platform constructed of concrete blocks or bricks. Pipes should preferably be made of PVC.
Page 5
TO CLEAN BACKWASH THE FILTER When the pressure has increased by 0.5 bar or more (the measurement registered above) the filter sand needs to be backwashed. This is done as follows: 1. Shut off the pump. 2. Shift the valve handle to “Filter backwash”. 3.
Page 6
TROUBLESHOOTING 1. Short Cycle between backwashes. A. Flow rate too high or filter too small: consult dealer for system sizing recommendations. B. Water is chemically out of balance: consult pool serviceman. C. Excess dirt/dust in pool: vacuum pool directly to waste. D.
Page 7
DOME COMPOUND RESISTANCE The filters dome is not resistant to all lubricants and sprays. Next table indicates the resistance to most common compounds.
Need help?
Do you have a question about the TRITON NEO and is the answer not in the manual?
Questions and answers