Advertisement
Quick Links
MLS
ALPHA COMMUNICATIONS ®
from
ALPHA-PAGE v3.2
Call/Alarm/Fault signal monitoring-paging system
Installation/Owners Manual
Alpha Communications ®
TOLL-FREE Technical Line 1-800-666-4800
42 Central Drive - Farmingdale NY 11735-1202
Phone: 631-777-5500
Fax: 631-777-5599
Website: www.alpha-comm.com
Email: info@alpha-comm.com
AWD049
Rev. 1 (02/97)
Advertisement
Related Manuals for Alpha Communications MLS
Summary of Contents for Alpha Communications MLS
- Page 1 ALPHA COMMUNICATIONS ® from ALPHA-PAGE v3.2 Call/Alarm/Fault signal monitoring-paging system Installation/Owners Manual Alpha Communications ® TOLL-FREE Technical Line 1-800-666-4800 42 Central Drive - Farmingdale NY 11735-1202 Phone: 631-777-5500 Fax: 631-777-5599 Website: www.alpha-comm.com Email: info@alpha-comm.com AWD049 Rev. 1 (02/97)
- Page 2 *** NOTICE *** The Alpha-page digital pager interface system is an extremely reliable system for sending nurse call and other alarm messages to pocket pagers. The system sends messages to your pager(s) using a relatively high power radio signal. This signal has considerable range and has the ability to reject radio "noise" which could corrupt the message being sent.
- Page 3 Determine a suitable location for the MLS-EC1. Remember, wiring from each alarm/fault contact needs to be run to the MLS-EC1. Mount the MLS-EC1 in a location that will allow the most convenient means of running the required wiring between the contacts being monitored and Alpha-page.
- Page 4 MLS-EC1 enclosure. Use the data cable access hole provided in the MLS-EC1 enclosure to get the data and power cord into the enclosure to the MLS-SPU1 board. Refer to drawing C051398-1 for connecting the PT-400 to Alpha-page.
- Page 5 Relationship between MLS-32L terminal number, MLS-32L board number and programming input number MLS-32L board number terminal:...
-
Page 6: Message Programming
The black wire of the MLS-H1 battery cord must be connected to the negative (-) terminal of the battery. The other end of the MLS-H1 cord is connected to the MLS-SPU1 board. Connect the red wire to the "B+" terminal . Connect the black wire to the "B-"... -
Page 7: Maintenance
The pager field is located at the lower left of the LCD. Use the <tab> key to move the cursor from the message field to the pager field. Pagers are factory programmed with one or more 7 digit capcodes. The back of each pager is labeled with the capcodes it contains. -
Page 8: Troubleshooting
Both pager numbers assigned to the message are 00. Messages assigned with pager number 00 are not transmitted to any pager. Make sure power and data cable for PT-400 transmitter are properly connected to MLS- SPU1 board. Refer to drawing in this manual. - Page 9 input number wired to: input number wired to:...
- Page 10 input number wired to: input number wired to:...
- Page 11 input number wired to: input number wired to:...
- Page 12 input number wired to: input number wired to:...
- Page 13 Alpha Communications...
- Page 14 Alpha Communications...
- Page 15 Alpha Communications...
- Page 16 Alpha Communications...
- Page 17 Alpha Communications...
- Page 18 Alpha Communications...
- Page 19 Alpha Communications...
- Page 20 Alpha Communications...
- Page 21 Alpha Communications...
- Page 22 Alpha Communications...
- Page 23 Alpha Communications...
- Page 24 Alpha Communications...
- Page 25 Alpha Communications...