CONNECTIONS ..................................16 COMMISSIONING AND METHOD OF USE ............................17 OPERATION OF THE CONTROL PANEL ON THE MACHINE, WIFI AND REMOTE CONTROL ............ 17 TURNING THE UNIT ON AND OFF ............................18 Innova Srl Page 2 Manual 2.0 RINNOVA CEILING...
Page 3
ALARMS ......................................24 GENERALITY ................................... 24 PROBLEMS WITHOUT ERROR INDICATION ON THE DISPLAY ....................24 TABLE OF ALARMS SIGNALED BY DISPLAY ..........................25 NOTES AND INFORMATION MAINTENANCE ........................... 26 NOTE ........................................26 Innova Srl Page 3 Manual 2.0 RINNOVA CEILING...
Do not put R410A into the atmosphere: R410A is a fluorinated greenhouse gas, referred to in the Kyoto protocol, with a global warming potential (GWP) = 1975. 1.3 SYMBOLOGY The symbols shown in the following booklet allow you to quickly provide information necessary for the correct use of the unit. Safety symbols Innova Srl Page 4 Manual 2.0 RINNOVA CEILING...
Make sure that the earth connection is made; do not ground the appliance on distribution pipes. Momentary surges of high intensity could damage the unit Innova Srl Page 5 Manual 2.0 RINNOVA CEILING...
The unit allows the active recovery of the energy of the expelled air. Thanks to its refrigeration circuit, the thermodynamic recovery allows to supply energy to the environment in greater quantities than that subtracted from ventilation for 90% of the unit's operation; Innova Srl Page 6 Manual 2.0 RINNOVA CEILING...
Remote panel to be purchased optionally with WIFI or MODBUS RTU for connection up to 10m from the unit for the recessed versions; 1.8 MAIN COMPONENTS OF THE UNIT Innova Srl Page 7 Manual 2.0 RINNOVA CEILING...
1.11 DISASSEMBLY AND DISPOSAL Do not disassemble or dispose of the product yourself. Disassembly, demolition, disposal of the product must be carried out by authorized personnel in compliance with local regulations. Innova Srl Page 8 Manual 2.0 RINNOVA CEILING...
Remove the screws of the side panels by removing the 4 screws on the front; Push the side to make it come out of the rear seats and remove Innova Srl Page 9 Manual 2.0 RINNOVA CEILING...
The condensate drain comes out as standard in the rear part of the unit where there should be the hole in the wall as shown alongside; Innova Srl Page 10 Manual 2.0 RINNOVA CEILING...
Unit 2.0 RENEW CEILING Ø External air mm Ø Expulsion mm 160mm We recommend installing at least 500mm of flexible piping to avoid dragging of vibrations and annoying noises due to installation. Innova Srl Page 11 Manual 2.0 RINNOVA CEILING...
Page 12
Air flow configurations 2.0 RINNOVA CEILING VIEW FROM TOP Innova Srl Page 12 Manual 2.0 RINNOVA CEILING...
Keep in mind that the grilles open when the outside air flow is activated to allow the cooling or heating function. For their testing it is therefore essential to operate the air conditioner to cool or heat Mounting external grids Innova Srl Page 13 Manual 2.0 RINNOVA CEILING...
Furthermore, in the lower part, the electrical panel can be reached with a dedicated door Condensate drain connection Innova Srl Page 14 Manual 2.0 RINNOVA CEILING...
To insert the battery, open the special snap door located in the lower part of the remote control. The battery must be inserted carefully respecting the polarity. Close the snap door once the battery is inserted. Remote control batteries Innova Srl Page 15 Manual 2.0 RINNOVA CEILING...
CP- REMOTE ON OFF Provides an external connection to enable the unit as a presence or window contact; Comes with a deck supplied; Connections Innova Srl Page 16 Manual 2.0 RINNOVA CEILING...
- giving it strong shocks or dropping it on hard surfaces - leaving it exposed to sunlight Wifi machine board panel Remote controller Innova Srl Page 17 Manual 2.0 RINNOVA CEILING...
In dehumidification only and night comfort mode, power control is not possible as the appliance can only operate at minimum. Fan speed management Innova Srl Page 18 Manual 2.0 RINNOVA CEILING...
In this mode, both the ambient temperature setting and the fan speed setting are ignored, which always corresponds to the minimum. In this mode it is normal for the appliance to operate intermittently Dehumidification Innova Srl Page 19 Manual 2.0 RINNOVA CEILING...
For each speed, if the air quality is not optimal, the fans increase the flow rates to have greater air exchange and improve the quality of the internal air; Innova Srl Page 20 Manual 2.0 RINNOVA CEILING...
-The unit provides for the operation of a UVC lamp with germicidal action placed in the section where the new air enters; The lamp is activated automatically when the ventilation is activated; Innova Srl Page 21 Manual 2.0 RINNOVA CEILING...
Reposition the lower panel in its seats and insert the screws in the front part; Reposition the grill in its seat; View for filter extraction Innova Srl Page 22 Manual 2.0 RINNOVA CEILING...
- Reinsert the filter in its seat; -Finally, place the front grille, Attention Never perform these operations with the lamp and unit powered; UVC rays can cause damage to the skin and eyes; View for lamp maintenance Innova Srl Page 23 Manual 2.0 RINNOVA CEILING...
Check for cracks and / or air leaks from the unit panels Check the siphon connection Check if the motors turn correctly (bearings) Noise coming from the ducts Check for cracks in the intake / inlet / exhaust pipes Innova Srl Page 24 Manual 2.0 RINNOVA CEILING...
It is not possible to activate any operation of the appliance. failure CP presence contact open The device is activated only if the contact is closed. Check the connection of the terminals. Innova Srl Page 25 Manual 2.0 RINNOVA CEILING...
Page 28
05 20 20 re v.3 Technical Assistance Center The data contained in this manual can be changed by the manufacturer without prior notice. Innova Srl Page 28 Manual 2.0 RINNOVA CEILING...
Need help?
Do you have a question about the 2.0 RINNOVA CEILING and is the answer not in the manual?
Questions and answers