Steelcase 9000 E.I.P. Corner Work Surface Series Assembly Instructions
Steelcase 9000 E.I.P. Corner Work Surface Series Assembly Instructions

Steelcase 9000 E.I.P. Corner Work Surface Series Assembly Instructions

Advertisement

Series 9000
If you have a problem,
Models: S-98864 thru S-98872 and S-98874 thru S-98881
question, or request,
call your local dealer
or Steelcase Line 1 at
888.STEELCASE
(888.783.3522)
Outside the U.S.A. call:
1.616.246.4880
Or visit our website
www.steelcase.com
Si vous avez un problème,
question, ou demande,
appeler votre revendeur local
ou ligne 1 de Steelcase à
888.STEELCASE
(888,783,3522)
En dehors des Etats-Unis
appel: 1,616,246,4880
Ou visiter notre website
www.steelcase.com
Si usted tiene un problema,
pregunta, o petición,
llame a su distribuidor local
o línea 1 de Steelcase en
888.STEELCASE
(888,783,3522)
Fuera de los E.E.U.U.
llamada: 1,616,246,4880
O visite nuestro website
www.steelcase.com
c
1998 Steelcase Inc.
Rapids Grand, MI 49501
U.S.A.
Les ETATS-UNIS.
Los E.E.U.U.
Printed in U.S.A.
Imprimé aux Etats-Unis.
Impreso en los E.E.U.U.
®
E.I.P. Corner Work Surfaces
1
of
9/64" Drill Bit
3
939501047 Rev B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 9000 E.I.P. Corner Work Surface Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Steelcase 9000 E.I.P. Corner Work Surface Series

  • Page 1 Outside the U.S.A. call: 1.616.246.4880 Or visit our website www.steelcase.com Si vous avez un problème, question, ou demande, appeler votre revendeur local ou ligne 1 de Steelcase à 888.STEELCASE (888,783,3522) En dehors des Etats-Unis appel: 1,616,246,4880 Ou visiter notre website www.steelcase.com Si usted tiene un problema, pregunta, o petición,...
  • Page 2 Refer to recommended work surface height chart below. After selecting the desired height of work surface,measure up from the floor and place a pencil mark of piece of masking tape on panel upright to indicate where the top of cantilevered end support assembly must be located.
  • Page 3 Insert tabs on rear corner support bracket into slots between panel upright and panel surface. Mount support brackets to cantilever using 1/4-20 x 1/2” bolts. Position work surface onto cantilevered supports and secure with (4) #10 x 7/8” wood screws. DO NOT TIGHTEN AT THIS TIME! Next, using holes in rear corner support bracket as a template.

This manual is also suitable for:

S-98864S-98872S-98874S-98881

Table of Contents