Table of Contents
Advertisement
¦ chapter 5 trouble shooting
FireWire (IEEE1394) and USB 2.0 Problems
The USB device does not work -
n
Windows NT 4.0 does not support USB protocols
n
Check the settings in the Windows Control Panel.
n
Make sure you have installed the necessary device drivers.
n
Contact the device vendor for additional support.
The IEEE1394 port does not work -
n
Go to [Start > Settings > Control Panel > Performance and Maintenance > System > Hardware >
Device Manager]. You should see an entry which reads "Texas Instrument OHCI Compliant IEEE 1394 Host
Controllers". If it does not exist, Windows has not detected the host controller or the device driver has not
been installed properly. If there is a yellow mark or red-cross on the 1394 host controller, it may be a device
or resource conflict. Replace or update the device driver from the factory CD-ROM disk or consult the
Windows manual on how to solve the resource conflict problem.
n
Make sure the cable is fully connected.
n
Make sure you have installed the necessary device drivers.
n
Contact the device vendor for additional support.
5-10
Advertisement
Table of Contents
