Firewire (Ieee1394) And Usb2.0 Problems - AVERATEC AV6110-EH1 Getting To Know Manual

■ chapter 5 trouble shooting

Firewire (IEEE1394) and USB2.0 Problems

The USB device does not work -
Windows NT 4.0 does not support USB protocols
Check the settings in the Windows Control Panel.
Make sure you have installed the necessary device drivers.
Contact the device vendor for additional support.
The IEEE1394 port does not work -
Go to [Start > Settings > Control Panel > System > Hardware > Device Manager]. You should see an
entry which reads "IEEE 1394 Bus host controllers". If it does not exist, Windows has not detected the host
controller or the device driver has not been installed properly. If there is a yellow mark or red-cross on the
1394 host controller, it may be a device or resource conflict. Replace or update the device driver from the
factory CD-ROM disk or consult Windows manual on how to solve the resource conflict problem.
Make sure the cable is fully connected.
Make sure you have installed the necessary device drivers.
Contact the device vendor for additional support.
5-15