AVERATEC AV4265-EH1 User Manual page 63

¦ appendix B agency regulatory notices
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
n
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and the receiver.
n
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
n
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly
approved by the Manufacture may void the user's authority to operate the equipment.
Connections to Peripheral Devices
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Declaration of Conformity
This device complies with Part 15( CLASS B)/68 the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
European Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC)
and R&TTE Directive (1999/5/EC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms:
n
EN55022 : 1998+A1: 2000+A2: 2003, CLASS B
n
EN61000-3-2 : 2000
n
EN61000-3-3 : 1995+A1: 2001
n
EN55024 : 1998+A1 : 2001+A1: 2003
n
IEC61000-4-2: 2001
n
IEC61000-4-3:2002+A1:2002
n
IEC61000-4-4:1995+A1:2000+A2:2001
n
IEC61000-4-5:2001
n
IEC61000-4-6:2001
n
IEC61000-4-8:2001
n
IEC61000-4-11:2001
n
EN50082 (IEC801-2, IEC801-3, IEC801-4) Electro-magnetic Immunity
n
EN 300 328-2, EN 300 328-1, EN 301 489-1, EN 301 489-17 (ETSI 300 328, ETSI 301 489) Electro-magnetic
Compatibility and Radio Spectrum Matter.
n
TBR21 ( ETSI TBR21) Terminal Equipment.
n
EN60950 (IEC60950) I.T.E. Product Safety
Canadian Notice
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the
radio interference regulations of the Canadian Department of Communications.
Le present appareil numerique nemet pas de bruits radioelectriques depassant les limites applicables aux appareils
numeriques de Classe B prescrites dans le reglement sur le brouillage radioelectrique edicte par le Ministere des
Communications du Canada.
Power Cord Requirement
The power cord supplied with the AC adapter should match the plug and voltage requirements for your local area.
Regulatory approval for the AC adapter has been obtained using the power cord for the local area. However, if you travel to
a different area and need to connect to a different outlet or voltage, you should use one of the power cords listed below. To
B-2