Operation - Haussmann 59595062 Operator's Manual

If you are experiencing premature wear of the backing pad facing,
decrease the amount of pressure you are applying during operation of
the tool.
Fig. 2
Fig. 3 Fig. 4

oPeration

WarninG! Always use the correct voltage:The voltage of the power
source must match with the values on the nameplate of the tool.
1.Slide "on/off" SWitcH
The tool is switched "ON" by the slide switch located on the top of the
motor housing
Switching on:
TO TURN THE TOOL "ON" slide the switch button forward to the "I" .
Switching off:
TO TURN THE TOOL "OFF" slide the switch button backward to the "0"
.
WARNING! Hold the tool with both hands while starting the tool, since
torque from the motor can cause the tool to twist.
Selecting the oscillation speed
NOTE: The required oscillation speed depends on the material and the
working conditions and can be determined by testing on a scrap piece
of material.
Preselect the required oscillation speed using the oscillation speed
setting wheel (2).
auxiliary Handle When working with the tool, always use the auxiliary
handle.
Attach the auxiliary handle (7) on the tool head depending on the
chosen working method.
This tool has two holes to change the auxiliary handle position.
2.SaWinG
Use only saw blades in perfect condition.
Deformed, blunt saw blades or saw blades that are otherwise damaged
can break.
When sawing light building materials, observe the statutory provisions
and the recommendations of the material suppliers.
Plunge cuts may only be applied to soft materials, such as wood,
gypsum plaster boards, etc.
Before sawing with HSS saw blades in wood, particle board, building
8