Auto Dial; Night Service - AT&T Merlin Legend BIS22D Quick Reference

OFTEN USED FEATURES
Messaging Cont'd
To turn message light on/off on
MERLIN II System Display
Console:
On MERLIN II System Display
consoles, you can use a Message
Status button to check the status
of a co-worker's message light. If
your DSS has additional
extensions on each DSS, you must
use the appropriate shift button to
see message status for these
extensions.
1. Press Message Status
button.
2. Check green light next to
DSS button for the extension
(use shift button, if
necessary).
To leave message light
unaffected, press
Message Status button.
To turn message light on
or off, press Send/
Remove Message
button, or press Feature
and dial 38 and press
DSS button for the
extension. Press
Message Status to
return to call handling.
Post Messages
To program:
See Programming Buttons.
To post:
1. Press programmed button.
2. Dial posted message code
(01-20).
To cancel:
1. Press programmed button.
2. Dial 00.
Camp On
To program:
See Programming Buttons,
To use camp on:
1. If you have camp on with
manual dial:
a. Press Transfer.
b. Dial extension.
one-touch transfer with
manual completion:
- While active on a call,
press DSS or Auto Dial
button.
2. Press programmed button or
press Feature and dial 57.
3. Hang up, press Speaker o r
Speakerphone of use
headset.

Night Service

To program:
See Programming Buttons.
To use:
1. Press programmed button.
2. Dial password, if necessary.
You have 60 seconds to enter
the password.
System Speed Dial
Use company-programmed 3-digit
codes to dial phone numbers. Ask
your system manager for a list of
numbers and their associated codes.
To program:
1. Label button.
2. Slide T/P switch to P.
3. Press labeled button.
4. Dial * 2 4 .
5. Dial 3-digit company-supplied
speed dial code.
6. Slide T/P switch to center.
To use:
1 . Lift handset, Speaker or
Speakerphone or use
headset.
2 . Press programmed button, or
press Feature and dial 3-digit
company-supplied speed dial
code.

Auto Dial

To program:
1. Label a button.
2. Slide T/P switch to P.
Press labeled button.
3.
4. Dial *22 for inside numbers
or *21 for outside numbers.
5. Dial extension or outside
number, (Include entire
dialing sequence, including
dial-out codes. See Special
Characters Table.)
Repeat Steps 3-5 to program
6.
additional buttons.
7. Slide T/P switch to center.
To use outside Auto Dial button:
Press programmed Auto Dial
button.
To use inside Auto Dial button:
1. Press appropriate ICOM or
SA button.
2. Press programmed Auto Dial
button.
Special
Characters Table
Features that dial numbers automatically
may need special characters to allow for
correct dialing or system response.
Press...
See... Means...
Drop s Stop. Halts dialing
sequence to allow for
system response.
Hold Pause. Inserts 1.5 sec.
P
pause in auto dialing.
More than one consecutive
pause allowed.
Conference f Flash, Sends
switchhook flash.
## #
Extension Programming
only: End of Dialing.
Completes dialing
sequence or use to
separate grouped
digits.
# # End of Dialing.
Completes dialing
sequence or use to
separate grouped digits.