THOMSON Grass Valley Kameleon Series Instruction Manual page 54

Multi-function modules

Table of Contents

KAM-AV and KAM-SD Links and Web Pages

Figure 27

illustrates the KAM-AA-MIX-BR Rear module I/O Config web

page. The type of submodule in Position 1 will determine whether Analog

Audio connectors J8 and J9 are inputs or outputs. The submodule in Posi-

tion 2 will determine whether Analog Audio connectors J5 and J6 are

inputs or outputs.

AES balanced connectors J3 and J4 can be defined as inputs or outputs with

the pulldown controls on this I/O web page. Refer to

submodule I/O combinations.

There are two identical SDI video outputs at connectors J1 and J2.

Note

If the KAM-AA-MIX-BR Rear module is installed in a frame with a 2000NET

module running version 3.2.2 or earlier software, the dual Analog and AES

audio graphics will be shown as boxes with red X's. Functionality is not

affected. This rear module requires 2000NET software 4.0.0 or later to recog-

nize the dual graphics.

Refer to

Table 7 on page 28

on page 27

for cabling information.

Figure 27. KAM-AA-MIX-BR Rear Module I/O Configuration Web Page

for submodule I/O combinations and

Kameleon Series Instruction Manual

Table 6 on page 26

for

Figure 14

Table of Contents