THOMSON Grass Valley Kameleon Series Instruction Manual page 16

Installation
post and receptacle
16
Figure 4. Installing Passive Rear Module
2000 frame (rear view)
Rear alignment
KAM passive rear module
3. Verify that the module connector seats properly against the midplane.
4. Using a crossblade screwdriver, tighten the two screw locks to secure
the module in the frame.
5. If an ADC and/or DAC audio submodule option has been ordered, the
submodule will be provided with the front processing media module.
Placement of the submodule depends on the desired audio I/O config-
uration from the rear module type being used. The installation of the
submodule will determine the functionality of the input and output
audio connectors on each side of the rear module.
As illustrated in
the left side of the rear module. Submodule 2 is wired to the right side
connectors.
Figure 5. Submodule/Rear Connector Relationship
Wired to left side connectors
Submodule 1
Submodule 2
Refer to the rear module cabling information tables for correct place-
ment of the submodules to match your requirements as follows:
Figure 5, Submodule 1 is wired to the connectors on
KAM-AA Rear connectors shown,
same relationship for other rear modules
Wired to right side connectors
Kameleon Series Instruction Manual
Board edge guides
(both sides)
Screw lock
(both sides)