Table of Contents
Advertisement
4. Install the new batteries, ensuring correct polarity alignment
(figure 1).
5. Place the battery cover on the back of the instrument and
tighten the four screws. Do not over-tighten.
Figure 1. Pro1030 with battery cover removed. Notice
battery symbols indicating polarities.
The waterproof instrument case is sealed at the factory and
is not to be opened, except by factory-authorized service
i
technicians. Do not attempt to separate the two halves of the
instrument case as this may damage the instrument, break the
waterproof seal, and will void the warranty.
Key pad
2
1
Figure 2, Keypad
3
4
5
6
2
Number
Key
1
Press and hold for 3 seconds to calibrate.
2
Use to navigate through menus, to
navigate through box options along
the bottom of the Run screen and
3
Press once to turn instrument on. Press a
second time to turn backlight on. Press a
third time to turn backlight off. Press and
hold for 3 seconds to turn instrument off.
4
Press to enter the System Setup
5
Press to confirm entries and selections.
6
Use to navigate through menus, to
navigate through box options at
the bottom of the Run screen and
connectIng the sensor and caBle
"Bulkhead" refers to the single-pin connector at the end of the probe/
cable assembly where an ISE sensor, either pH or oRP, is installed
(figure 3). The conductivity and temperature sensors are located above
and next to the bulkhead and are not replaceable.
Description
calibrate
opens Calibrate menu
from the Run screen.
Up arrow
to increase numerical inputs.
power and Backlight
Menu
menu from the Run screen.
enter
down arrow
to decrease numerical inputs.
3
Advertisement
Table of Contents
