Advertisement
Description of this Upgrade
Step 16. Perform Post-Upgrade Adjustments and Calibration
Figure 16 Connect sensor at the end of one of the cables from the HMA26.5
If the instrument has Option 422/423, it may have Option XSB installed
and SOURCE3
Remember to reconnect the load to SR3 J13 on the rear panel.
1. Option XSB (Source 3) is only orderable on instruments with Option 422/423.
In the Synthesizer to Calibrate area, only the sources that are installed are
available for calibration (i.e., Source 2 and Src 3 (XSB)
(grayed out) when not installed).
1. Option XSB (Source 3) is only orderable on instruments with Option 422/423. Source 2 is not available on all models.
— source adjustment
— IF gain adjustment
— receiver adjustment
— receiver characterization
Installation Note N5225-90142
3. LO Drive Adjustment
4. Perform PNA Source Power Adjustment.
1
will be available to adjust.
5. In the Synthesizer Calibrations – WSynth Calibrations window:
Press Program Files > Keysight > Network Analyzer > Service >
WSynth
1
are inactive
33
Advertisement
