Advertisement
Description of this Upgrade
Step 1. Verify PNA and Erase Flash
Step 1. Verify PNA and Erase Flash
This section verifies the PNA boots normally and if OK, deletes the flash in
preparation for installing and calibrating the new synthesizer assembly. Refer
to
1. Turn on your PNA.
2. Verify it boots up without errors.
3. If your PNA boots up normally.
4. Open the SCPI Parser Console: System > System Setup... > Remote
Installation Note N5225-90142
Figure 1 on page
12.
If there are errors, refer to your instrument's Chapter 4 "Troubleshooting"
in the PDF Service Guide
Interface... > then click Show SCPI Parser Console
1. See
"Downloading the Online PNA Service Guide" on page
1
.
5.
11
Advertisement
