Advertisement
Description of this Upgrade
Step 12. Remove and Replace the A55 Solid State Drive (SSD)
Step 12. Remove and Replace the A55 Solid State Drive (SSD)
Skip this step, if your PNA already has a 256 GB SSD (N5242-60135)
installed.
For instructions, click the Chapter 7 bookmark "Removing and Replacing the
A55 Solid State Drive (SSD)" in the PDF Service Guide
Step 13. Boot the Instrument
1. Power up the instrument and allow it to run for a couple of minutes to
2. If the instrument stabilizes without errors, continue to the next step.
Else, if the unit still has initialization errors which look like problems that
cannot be resolved, contact the Keysight Technologies. Refer to
Assistance from Keysight" on page
Step 14. Reinstall the Inner and Outer Covers
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the
PDF Service Guide
Step 15. Verify the PNA Analyzer Program is Running with the
Correct Options
If if the option(s) have not been enabled or if your older options have not
been removed, contact Keysight Technologies. Refer to
Assistance from Keysight" on page
1. Start the Network Analyzer program.
2. Once the Network Analyzer program is running:
3. After successful installation of all upgrades, some features require some
Installation Note N5225-90142
stabilize. This may require several reboots.
1
.
— Press Help > About NA and verify that the correct options are listed
in the PNA application.
adjustments to ensure the instrument meets its specified performance.
Refer to the following Web site: http://na.support.keysight.com/pna.
1. See
"Downloading the Online PNA Service Guide" on page
1
.
4.
"Getting
4.
5.
"Getting
31
Advertisement
