Download From Driver Card - inelo TachoReader Mobile II Manual

TachoReader Mobile II
1. Turn the vehicle key in the position II (ignition)
board flash (tachograph activation).
We recommend to perform these operation together with the driver.
2. Insert the company card / control card into slot
3
. The tachograph detects the card. Confirm the checkback "Company lock yes/no".
4
. Plug your TachoReader Mobile II into the tachograph interface.
Position of the interface within the tachograph - see tachograph manual.
5
. The TachoReader Mobile II starts the download automatically (both
Depending on the data range the download can take up to
Flash the LEDs in the device with red light during the download then see:
6 A
. fter the download both
Repeat the download when a download fault is signaled. When the repeated download is faulty as well,
try to download data from another tachograph.
If the download from another tachograph is OK, the first tachograph may be disturbed (visit a
tachograph service station).
When the second download is disturbed contact the
7 A
. fter reading, unplug the device from the tachograph and remove company card / control
card.
After pressing the reject button, you are asked, if the company lock has to be activated.
ALWAYS
It is useful to
persons could download data and lock the tachograph for their own company card).

2.4. Download from driver card

To download driver card data:
Operations after connecting to a computer
LE
Ds beam green (they beam red by download faults).
set the company lock, to avoid downloading of data by third parties (external
–
the control lamps on the instrument
1 2
or in the tachograph.
1 hour
time.
"Error codes
service of the TachoReader manufacturer.
44
LE
D flashing green).
".
13
10