Inserting The Bobbin 2:8; Thread Sensor 2:8; Snapping On And Off The Presser Foot 2:8 - Singer EM9305 User Manual

INSERTING THE BOBBIN
1. Remove the bobbin cover by sliding it towards you.
2. Place the bobbin in the bobbin case. It drops in only one
way with the logo facing up. The thread unreels from the
left of the bobbin. The bobbin will then rotate counter-
clockwise when you pull the thread.
3. Place your finger on the bobbin to keep it from turning as
you pull the thread firmly to the right and then to the left
into the tension spring (E) until it "clicks" into place.
4. Continue threading around (F) and to the right of the thread
cutter (G). Slide on the bobbin cover (H). Pull the thread to
the left to cut (I).
THREAD SENSOR
If the upper thread breaks or bobbin thread runs out, the
machine stops and a pop-up appears on the screen.
If upper thread breaks: Re-thread the machine and touch OK
on the pop-up. If bobbin thread runs out: replace with a wound
bobbin and continue embroidering.
Note: When the bobbin thread is almost empty, the bobbin
thread low pop-up appears on the screen. You can continue
embroidering without closing the pop-up before the bobbin
thread runs out completely.
SNAPPING ON AND OFF THE
PRESSER FOOT
1. To snap off the presser foot, first make sure the needle is in
the highest position and the presser foot is lifted. Pull the
presser foot towards you.
2. To snap on the presser foot, line up the cross pin on the foot
with the gap in the presser foot ankle. Push back until the
foot snaps into place.
2:8
1.
F
E
G
3.
1.
2.
2.
I
H
4.