Singer EM9305 User Manual page 60

The Machine Skips Stitches
Is the needle bent or blunt?
Did you insert the needle properly?
Did you insert a wrong needle?
Did you thread the machine properly?
Is the correct presser foot used?
Is the needle too small for the thread?
The Seam has uneven Stitches
Is the thread tension correct?
Are you using too thick or slubbed thread?
Is the bobbin thread evenly wound?
Is a correct needle used?
Thread loops are forming on the underside of the embroidery design
Has the embroidery built up too much to move
freely under the presser foot?
The Embroidery Design is Distorted
Is the fabric hooped properly?
Is the inner embroidery hoop completely
inserted in the outer embroidery hoop?
Is the area around the embroidery arm free?
The Embroidery Design has Puckered
Did you stabilize your fabric sufficiently?
The Machine will not Embroider
Is the embroidery unit attached?
Is the wrong hoop attached?
System report
Is your machine displaying the system report
pop-up?
8:4
Insert a new needle, see page 2:9.
Insert needle correctly as described on page 2:9.
Use needle system 130/705 H or 130/705 H-S.
Check how the machine is threaded, see page 2:5.
Attach correct presser foot.
Change the needle.
Check needle thread tension and the threading.
Change the thread.
Check bobbin winding (see page 2:7).
Insert a proper needle correctly as described on page 2:9.
Reduce the presser foot height in Embroidery Settings in SET menu in small
steps until problem is solved.
The fabric must be tightly hooped.
Hoop the fabric in such a way that the inner hoop exactly matches the outer
hoop.
Clear area around the embroidery unit and recalibrate.
Ensure you use the proper stabilizer for your technique or fabric type.
Make sure that the embroidery unit is properly attached into the socket.
Slide on the correct hoop.
When the system report pop-up appears, go to My Files/Reports and locate the
file (SystemReport01.dmp or higher number). Save the file to a USB stick. Send
the file together with a short description of what you were doing before the pop-
up appeared to product.improvement@singer.com. After sending the file, remove
it from your machine.