Removing The Bobbin Case; Inserting The Bobbin Into The Case; Inserting The Bobbin Case Into The Hook - Singer 6180 Operation And Safety Notes

left again, remove the bobbin and cut off the
end of the thread.
1
2
4

Removing the bobbin case

1. Bring the needle to the top position by turning
the handwheel forwards.
2. Open the free-arm flap by pulling it forwards.
Open the flap of the bobbin case (see dia-
gram), and pull the bobbin case out of the
hook.
3. Let go of the bobbin case flap and the bobbin
will fall out.
12 GB/IE
113223_Naehmaschine_Singer_Content_BE.indd 12
1. Take the bobbin case in your left hand and
3
2. Lay the thread into the slit in the case.
3. Draw the thread under the tension spring.
4. Pull about 15 cm thread out of the bobbin.
1. Grasp the bobbin case with your left hand,
2. Ensure that the thread is hanging outwards and
Inserting the bobbin into
the case
place the bobbin into the case in such a way
that the bobbin is turning clockwise.
Inserting the bobbin case
into the hook
open the flap and place the case with the case
finger above on the pin in the middle of the hook.
is not caught in the case.
09.02.15 12:01