Embroidery Stitch-Out Pop-Up Messages 6:8 - Singer EM9305 User Manual

EMBROIDERY STITCH-OUT POP-UP
MESSAGES
Embroidery Unit Calibration
When entering Embroidery Stitch-Out Mode by touching Go!
or when connecting the embroidery unit in Stitch-Out Mode,
a pop-up message will ask you to slide off the hoop and clear
the machine area for calibrating the embroidery arm. You will
also be reminded to attach the correct embroidery foot. If the
machine is already calibrated, the pop-up will not be displayed.
Note: DO NOT calibrate the machine with the embroidery
hoop attached as this can damage the needle, presser foot,
hoop and/or the embroidery unit. Be sure to clear all materials
from around the machine before calibrating so that the
embroidery arm does not bump into anything while calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does not match
the size displayed on screen, the machine cannot embroider.
You must change the hoop to the hoop size displayed in the
pop-up or change the hoop setting.
To change hoop settings, return to Embroidery Edit and touch
My Hoops icon.
Cut Thread End
When Automatic Jump Stitch Trim is deselected in the SET
menu, the thread ends will not be cut automatically. When a
new embroidery is started or the thread has been changed, the
machine will embroider a few stitches and then stop. A pop-up
message will now display, asking you to cut the thread.
To do so, hold the thread end, press the Selective Thread Cutter
button on the machine to cut the thread and remove the thread
tail that has been cut.
Note: When Automatic Jump Stitch Trim is selected in the SET
menu, thread ends are cut automatically. Simply remove the
thread tail that has been cut.
Bobbin Thread Low - move to bobbin position?
When the bobbin thread is running low, a pop-up message
appears giving you an advanced notice that you'll soon need
to change the bobbin. This gives you an opportunity to plan
when you want to change your bobbin. If you want to continue
embroidering just touch the Start/Stop button without touching
OK in the pop-up.
It is possible to embroider until the thread has completely
run out. Press the Start/Stop button to continue embroidering
without closing the Bobbin thread low pop-up.
Touch Cancel to remain at the current stitch position. Touch
OK to move the hoop to bobbin position. The hoop position
pop-up opens. Replace the empty bobbin with a full one. Touch
Current position and pull back excess needle thread. Press
Start/Stop to continue embroidering.
6:8
My Hoops icon
Selective Thread
Cutter button