Winding The Bobbin Using; The Vertical Spool Pin 2:7; The Auxiliary Spool Pin 2:7 - Singer EM9305 User Manual

WINDING THE BOBBIN USING

THE VERTICAL SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fits on one way, with the
logo facing up. Use only original SINGER
EF.
2. Place the large spool cap and a felt pad under the spool on
the main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B),
then through thread guide (C) as illustrated.
4. Guide the thread through the hole in the bobbin (D) from
the inside to the outside.
5. Push the bobbin winder spindle to the right to wind.
A pop-up appears on the screen to inform you that bobbin
winding is active. To adjust winding speed, use the slider in
the pop-up. Start bobbin winding by touching the start/stop
button.
When the bobbin is full, it will stop winding. Touch the
start/stop button to stop the bobbin winder motor from
running. Move the bobbin winder spindle to the left and the
pop-up will close. Remove the bobbin and cut the thread
using the bobbin thread cutter.
Note: It is important that you cut the thread end close to the
bobbin.
Note: Moving the bobbin spindle to the left will engage the
embroidery mechanism. Always stop winding by pushing the
Start/Stop button before moving the bobbin spindle.
WINDING THE BOBBIN USING
THE AUXILIARY SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fits on one way, with the
logo facing up. Use only original SINGER
EF.
2. Fold out the auxiliary spool pin. Place a spool cap and a felt
pad under the spool.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B),
then through thread guide (C) as illustrated.
4. See "Winding the Bobbin Using
the Vertical Spool Pin" on page 2:7, step 4–5.
A
bobbins, group
®
B
bobbins, group
®
A
B
C
D
D
C
S U
et p
2:7