Function Buttons - Singer EM9305 User Manual

FUNCTION BUTTONS

2
1
7
8
9
1. Start/Stop
Press Start/Stop to start or stop the machine embroidering.
Your machine stops automatically at color changes and when
the embroidery is finished.
2. Monochrome
By default, the machine will stop at color changes when
embroidering. If you want to create monochrome embroidery,
press Monochrome to eliminate stops for color changes.
Press once more on the button to turn monochrome mode off
again. You can also control the monochrome function via the
touch screen (see page 6:4).
Activating monochrome mode turns off the LED light next to
the button.
Note: If the Automatic Jump Stitch Trim function is selected in
the SET Menu it will still be active between the color blocks.
3. Baste
Press Baste to baste an outline of the embroidery design area or
to baste the fabric to the stabilizer.
4. Selective Thread Cutter
If you press the Selective Thread Cutter it automatically cuts
the top and bobbin threads and raises the presser foot. At the end
of a color block only the top thread is cut. When the design is
finished, both top and bobbin threads are cut automatically.
Note: Selective Thread Cutter Auto can be cancelled in the SET
Menu, see page 3:6
5. Trim Position
The machine will move the hoop forward, towards you, for
easy thread trimming.
3:2
3 4 5
6. SPEED - and +
Each stitch type in a design has a pre-set maximum speed at
which it can be embroidered. To reduce the speed when using
specialty threads or embroidering on delicate fabrics, press
Speed -. To increase the speed again press Speed +.
7. Sensor Foot Up And Extra Lift
Press Sensor Foot Up and Extra Lift to lift the presser foot to
Up position. Press once more and the presser foot will raise to
Extra Lift, to make it easier to insert or remove the hoop.
8. Sensor Foot Down
Press the Sensor Foot Down button to lower the presser foot
into the Embroidery "float" position.
Thanks to the sensor system, the presser foot continuously
senses the thickness of fabric, and embroiders over the fabric
smoothly and evenly with perfect fabric feeding.
Note: The presser foot is lowered automatically when you start
embroidering.
9. Update
Press and hold the Update button while starting the machine, to
update the machine software (see page 2:11).
Note: To perform the update, you will also need to connect a
USB stick, loaded with the latest software, to the machine.
6