York Altair Series User Manual page 13

High wall inverter
Table of Contents

Advertisement

Phenomenon
Air conditioner can
not operate at all.
Remote controller
is not available.
Cooling (Heating)
efficiency is not
good.
Indoor unit does not operate
immediately when the air
conditioner is restarted.
There is unusual smell
blowing from the outlet
after operation is started.
There is sound of running
water during the running
of air conditioner.
A slight "click" sound is
heard at the of start-up or
shut-down.
During the cooling operation,
the indoor unit outlet
sometimes will blow out mist.
Immediately stop all operations and cut off the power supply ,
contact our Service center locally in following situations.
▲ Shrill sound is heard or Unpleasant odor is emitted during the operation.
There is an abnormal heat in power supply cord and power plug
Accidentally pour impurities or water into the machine or the remote control.
Air switch or protection switch often breaks.
Has the power been shut down?
Is voltage too high or too low ?(measured by professionals)
Does it reach the set time for start up?
Does the circuit protection device trip?
● Is the remote controller out of effective distance to the indoor unit?
Are there any obstructions between the controller and the
signal receptor?
Is the setting temperature suitable?
● Is the air inlet or outlet obstructed?
Is indoor fan speed set at low speed?
Is there any heat source in your room?
If the air conditioner is turned on immediately after it is
turned off, the protective delay switch will delay the
operation for 3 to 5 minutes.
The air conditioner itself does not have undesirable
odor. If there is odor, it may be due to accumulation
of the odor in the environment. Please clean the air
filter or activate the cleaning function.
Sometimes the "hissing" sound of running water
can be heard. This is the sound of the flow of the
refrigerant, not a malfunction.
Due to temperature changes, panel and other parts
will swell, causing the sound of friction. This is normal,
not a fault.
This is because the indoor air is cooled rapidly. After it
runs for some time, the indoor temperature and
humidity will be reduced and the mist will disappear.
- 11 -
Troubleshooting
Troubleshooting
Is the wiring loose?
Is the battery exhausted?
Are air filter dirty?
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents