Outdoor Installation Guide - Kettler NEO 6 Assembly, Operation & Maintenance Instructions

Burner built-in gas barbecues with flame safeguard system
Table of Contents

Advertisement

Outdoor Installation Guide

This Appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant
areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection.
This appliance must not be used indoors. Do not use your barbecue in garages, porches, sheds or other enclosed
areas. The barbecue is not intended to be installed in or used on recreational vehicles (e.g. boats, camping vans)
and should not be placed close to or under any surfaces that will burn or are sensitive to heat. Do not block/
obstruct the flow of air and combustion around the barbecue housing while in use.
Any enclosure in which the appliance is used shall comply with one of the following:
1. An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead
cover.
2. Within a partial enclosure that includes an overhead cover and no more than two walls
3. Within a partial enclosure that includes an overhead cover and more than two walls, the following shall apply-
(i)
at least 25% of the total wall area is completely open: and
(ii)
at least 30% of the remaining wall area is open and unrestricted.
In the case of balconies, at least 20% of the total of the side, back and front wall areas shall be and remain open
and unrestricted.
Figure F1 - Outdoor Area - Example 1
Figure F2 - Outdoor Area - Example 2
Open side at
least 25% of
total wall area
Assembly, Operation & Maintenence Instructions
Both ends open
Figure F3 - Outdoor Area - Example 3
Open side at
least 25% of
total wall area
Figure F4 - Outdoor Area - Example 4
30% or more in total of
the remaining wall area
is open and unrestricted
30% or more in total of
the remaining wall area
is open and unrestricted
Page 7

Advertisement

Table of Contents
loading

Table of Contents