Table of Contents
Advertisement
Assembly Instructions
Barbecue Chassis Carton
Barbecue Chassis (with light switch & cable)
Fat Tray
Gas Hose & Regulator (Propane only)
Cross-over Tube
Burners x 6
Built-In Bracket Kit
Fastener Pack & Power Adaptor
NG Hose Kit (NG Only)
NG Hose
NG Regulator
Remove all components from the cartons and carefully check against Parts List. Make sure you thoroughly
inspect parts before assembly and do not assemble or operate a barbecue that appears damaged. Some
assembly will require the use of a Phillips Drive screwdriver. When connecting the hose and adaptor to the
gas inlet you will require a 17mm and a 19mm Spanner or an adjustable Wrench.
NOTE: Check 'Gas Type' and specification plate on left-hand side of barbecue, under the control panel.
Barbecue Assembly
1. Remove the fat tray from the barbecue and place to one side until required.
2. Attach the built-in bracket kit to the barbecue chassis.
3. Place and fit roasting hood onto barbecue.
4. Place the barbecue assembly into the built-in structure.
5. Fit vapouriser (RHS), grill (RHS), Baking Dish (centre) and plate (LHS) into the barbecue.
6. Line the fat tray with aluminium foil and slide the fat tray in position. Do not fill the fat tray with sand or cat
litter.
7. Leak test the gas system before use. Check gas hoses are not kinked or near any sharp edges. Check gas
cylinder (if used) is well protected.
8. The exact sequence for the electrical connections will depend on the construction of the built-in structure.
9. Read through the barbecue assembly sequence once before starting.
Assembly, Operation & Maintenence Instructions
Parts List
Cooking Plates Pack
Hot Plate
Grill Plate
Baking Dish
Vapouriser
Roasting Hood Carton
Roasting Hood (with lights)
Fastener Pack
Assembly Instructions
Page 14
Advertisement
Table of Contents
