Table of Contents
Advertisement
Natural Gas Conversion & Installation
Gas conversions can only be done by an authorised person.
Important – For The Consumer & Installer
1. Local authority requirements -
an authorised person in accordance with UK Gas safety regulations 2018. If you are unsure who this is,
please contact us.
2. Check the conversion kit is correct for your bbq, and that all parts are present
Check the table below for your model barbecue, and only use the parts listed for that model. Using
the incorrect gas injectors on a Neo BBQ can invalidate the warranty.
Item Description
BBQ gas valve injector (Ø1.8mm)
Natural gas label
Manifold inlet adaptor (NG) 3/8"x1/2"BSP
Natural gas regulator
Natural gas stainless steel hose
BBQ gas valve injector (Ø1.1mm)
Propane gas label
Propane hose and regulator
Important - For the Installer
1. Remove the burners from the BBQ (by removing the clip at the back of each burner).
2. Remove the injector from each gas valve using a spanner & replace with the new injector (Ø1.8mm for NG &
Ø1.1mm for Propane), taking care not to over-tighten the new injector.
3. Replace each burner and secure by replacing the clips.
For Propane to NG conversion:
4. Remove the Propane hose and regulator from the BBQ manifold inlet.
5. Add a small amount of approved sealant to the manifold's 3/8"BSP thread and screw on the NG inlet adaptor
until tight.
6. Add a small amount of approved sealant to the inlet adaptor's ½" BSPT thread and screw on the supplied
regulator (note that the arrow on the regulator should be pointing to the adaptor).
7. Add a small amount of approved sealant to the hose's ½" BSPT thread and screw onto the other end of the
regulator.
8. Cover the existing "propane" label with the supplied correctly sized "Natural gas" label.
9. Connect a manometer to the regulator. Turn off all valves & connect the gas hose to the natural gas supply.
Leak test as per the instructions (tighten any joints which leak & replace any faulty parts). Light two main BBQ
burners, set them to high and adjust the pressure (using the adjustment screw on the regulator) to 0.95kPa.
For NG to Propane conversion:
10. Remove the NG regulator, NG hose and manifold adaptor from the manifold.
11. Clean any sealant residue from the manifold inlet.
12. Screw the certified propane hose & regulator assembly to the inlet.
13. Leak test as per the instructions (tighten any joints which leak & replace any faulty parts).
14. The installer must instruct the consumer on the safe & correct operation of the BBQ and hand over all
operating instructions. Any spare parts and left over parts should be given to the consumer for safe keeping.
Assembly, Operation & Maintenence Instructions
All gas fitting work, service and repairs should only be performed by
Item Code
BBA0336
BBA0841
DCC0390
NGREG
DCA0425
BBA0272
BBA0831
CC711250
Quantity
Neo
6
1
1
1
1
6
1
1
Page 21
Advertisement
Table of Contents
