Table of Contents
Advertisement
Flame Safeguard System
Every gas valve on this appliance has a flame safeguard built into it for added safety. Once operating, the flow of
gas through the valves is affected by the flame on the burner it is controlling. The flame heats a thermocouple
(positioned to the right of the burner), which keeps the gas flowing (this works after 5-10 seconds of heating).
When the flame is removed from the thermocouple (for example the burner blows out in a strong wind), the
thermocouple cool down & turns off the gas flow within 90 seconds.
NOTE: The thermocouple and burner are set up & tested at manufacture. Take care not to knock or move the
thermocouple from its supplied position. Take care when burners are removed that they are replaced in the
same place. If the flame safeguard system continually fails to operate correctly, please check the troubleshooting
section of this manual.
Electrical System
The lighting system requires a 240Vac supply. The supplied power pack is rated to IP64, and supplies 12Vac with a
maximum output of 20VA. This transformer complies to UK regulations.
The two 10W, 12Vac globes (type G5.3) can be accessed by carefully removing the glass covers on the lamps
(disconnect from power supply first).
Assembly, Operation & Maintenence Instructions
Page 6
Advertisement
Table of Contents
