Table of Contents
Advertisement
Barbecue Assembly
A
5
11
6
17
17
Fitting the Built-In Brackets to the Barbecue Assembly
1. Place barbecue (part 1) on a raised surface (remove fat tray)
2. Screw the rear louvre rods (parts 5) to the back holes in the left (part 4) and right (part 3) brackets with M5 12
screws (parts 11). Note: The brackets havetheir top lips pointing away from the barbecue.
3. Align the brackets at either side of the barbecue, to match the holes in the brackets to the nutserts in the sides
of the barbecue. Note: There are two possible heights.
a) Top of barbecue sides level with the top of the brackets (use lower sets of bracket holes)
b) Top of barbecue sides level 20mm above the top of the brackets (use upper sets of bracket holes)
4. Thread M5 x 30 screws (parts 17) through 4 holes on each bracket, through a spacer (part 6) and screw into
the nutserts on the barbecue side.
Assembly, Operation & Maintenence Instructions
6
4
17
17
17
6
6
1
3
Page 17
Advertisement
Table of Contents
