Omron CJ Series Connection Manual page 21

12
CS/RS is displayed on Main
Display.
Press the ZERO/SET Key once.
Check that the following set
value is displayed on
Sub-display.
CS/RS control: OFF
(None: Default)
Press the ZERORST/ESC Key
twice.
*If the value is different, change
the value by pressing the ↑
(UP) or the ↓(DOWN) Keys.
13
RS232C is displayed on Main
Display.
Keep pressing the →(RIGHT)
or the ←(LEFT) Keys until
DELIMI is displayed.
Press the ZERO/SET Key once.
14
Check that the following set
value is displayed on
Sub-display.
Delimiter: CR (Default)
Press and hold the Mode
Switching Key for two seconds.
*If the value is different, change
the value by pressing the ↑
(UP) or the ↓(DOWN) Keys.
7．Serial Communications Connection Procedure
0ff
<Setting range>
OFF (Default)
/ON
cr
18