Fujitsu M1010 Manual page 41

Problem
The notebook
stops working
The printer does
not print
The radio
connection to a
network does not
work
8_AmiloMini_M1010_P27-29_E.indd 29
Possible Cause
Notebook is in energy
saving mode.
An application programme
has caused the
malfunction.
The battery is dead.
The printer is not switched
on.
The printer is not
connected correctly.
The printer driver is faulty
or not correctly installed,
or it is the wrong printer
driver.
The wireless component
is disabled.
The wireless component
is enabled. Despite this,
the wireless connection to
a network does not work.
T r o u b l e s h o o t i n g a n d t i p s
Possible Solution
Leave energy saving mode.
Close the application program or restart the
notebook (by restarting the operating system
or switching the device off and back on again).
Charge the battery.
or
Insert a charged battery.
or
Connect the mains adapter to the notebook.
Make sure that the printer is switched on and
is online (see the manuals supplied with the
printer).
Check that the cable connecting the notebook
and the printer is connected properly.
Check that the cable connecting the
notebook and the printer is connected
properly.
Check whether the correct printer driver is
loaded (see printer documentation).
Switch the radio components on ( see
"Wireless LAN and Bluetooth - switching on
and off", Page 19 ).
Check whether the radio connection i s
switched on via the software.
Further information on using the wireless
component can be found in the help files
(see "Information sources", Page 19 ).
29
9/8/08 1:20:25 PM