Chapter 27: Replacing The Side I/O-Board; Procedure; Post-Requisites - Dell Inspiron 24 5000 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
After conducting the following replacement procedure, and if the following cables were disconnected and removed in the
removal process reconnect and route through the respective routing guides the following cables:
● Antenna cables from the wireless-card.
● Speaker cable (SPEAKER) to the system board.
● Camera cable (WEBCAM) to the system board.
1. Replace the media-card reader board and the side I/O-board aligning the screw holes with the screw holes on the side I/O-
bracket.
2. Replace the four screws (M3x5) that secure the side I/O-board and the media-card reader board to the side I/O-bracket.
3. Replace the side I/O-bracket aligning the guiding pins and screw holes to the respective slots and screw holes on the middle
frame.
4. Replace the two screws (M3x5) that secure the side I/O-bracket to the middle frame.
5. Route the side I/O-board and media-card reader cables (MB-SUSBC and SDRDC1) through the routing guides on middle
frame.
6. Connect the side I/O-board cable (MB-SUSBC) to the side I/O-board
7. Connect the media-card reader cable (SDRDC1) to the media-card reader board.
Post-requisites
1. Replace the system-board
2. Replace the inner frame.
3. Replace the stand.
4. Replace the back cover.
Replacing the side I/O-board
computer. After working inside your computer, follow the instructions in
shield.
After working
www.dell.com/
Replacing the side I/O-board
27
41