Replacing The Side I/O-Board; Procedure - Dell Inspiron 24 5000 Service Manual

Identifier
Status
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Identifier
Status

Procedure

1 Align and place the side-I/O board onto the display-assembly base.
2 Replace the two screws (M2.5x3.5) that secure the side-I/O board to the display-assembly base.
3 Route the headset-port cable through the routing guide on the side-I/O board.
4 Connect the side-I/O power cable to the side-I/O board.
5 Connect the side-I/O cable to the side-I/O board.
6 Align the screw holes on the side-I/O board shield to the screw holes on the display-assembly base.
7 Replace the two screws (M3x5) that secure the side-I/O board shield to the display-assembly base.
8 Route the side-I/O cable, side-I/O power cable, and headset-port cable through the routing guides on the display-assembly base.
9 Connect the headset-port cable to the system board.
10 Connect the side-I/O power cable to the system board.
11 Connect the side-I/O cable to the system board.
56

Replacing the side I/O-board

GUID-2EFE7E92-337F-4710-A2AB-08FF9D39DEFF
Released
Replacing the side I/O-board
computer. After working inside your computer, follow the instructions in
GUID-7C30B643-5172-45A7-92D6-94B29515E0BB
Released
27
After working inside
www.dell.com/