Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Skipper DL850-270
Summary of Contents for Skipper DL850-270
- Page 1 The DL850-270(D) SAM-4682/3 (RevB) Doppler Log Getting started WWW.
- Page 2 Getting started with the DL850-270 This guide is a compressed version of the information found in the manuals ‘DL850 Operation and Installation Manual’, and ‘100mm Gate Valve for DL850 Operation and installation manual’ The diagrams can be found in greater detail in these manuals.
- Page 3 4. The unit is now ready to test. Turn on the appropriate power switch(es) pt 5. Press a button on the front panel. The unit will start and the display (with no data) will be displayed. Note: The factory default has brightness low and night picture and may need adjusting to be seen in bright sunlight.
- Page 4 Installing the Combo Tank and DL270 sensor in Tank. (See separate manual for full details) ComboTankInstManual.
- Page 5 Cabling The transducer cable should be routed to the transceiver box. Any excess cable should be coiled in an area with little electrical noise (i.e. not next to a motor or generator). Cables are 40m long as standard. The transceiver end of the cable is colour coded, and the transceiver screw terminals J503 and J502 are also colour coded.
- Page 7 Interfacing and connecting the NMEA outputs This is documented in the Operation and installation manual on page 43 If the docking options are required, connect the gyro NMEA input set to ROT signal to one of the comports. The pin numbers for each comport can be seen on the NMEA screen on the unit.
Need help?
Do you have a question about the DL850-270 and is the answer not in the manual?
Questions and answers