Assembly; Operation - Briggs & Stratton 2500 PSI Owner's Manual

IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
CARTON
1. Remove the parts bag, accessories, and inserts included
with pressure washer.
2. Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
3. Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension
• Safety Goggles
• Oil Bottle
• Parts Bag (which includes the following):
• Owner's Manual
• Engine Manual
• Owner's Registration Card
• Handle Attachment Hardware
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115. If calling for
assistance, please have the model, revision, and serial
number from the data tag available.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Add oil to the engine crankcase.
4. Add fuel to the fuel tank.
5. Connect the high pressure hose to the spray gun and
the pump.
6. Connect the water supply to the pump.
7. Attach nozzle extension to spray gun.
Speed Clean™ 2500 PSI Pressure Washer
5
Attach Handle
1. Place the handle assembly onto the handle supports
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure 1).
Figure 1 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert the carriage bolts through the holes from the
outside of the unit and attach a plastic knob from the
inside of the unit (Figure 2).Tighten by hand.
Figure 2 — Secure Handle
3. Insert one of the "L" hooks through the hole just
under the billboard on the left side of the handle
(viewing from rear of unit). Hold the hook in place
with a pliers and attach the locknut with a
7/16" wrench (Figure 3).
Figure 3 — Attach "L" Hooks to Handle
Hose Hook
4. Insert the other "L" hook through the hole just above
the billboard on the right side of the handle (viewing
from rear of unit). Hold the hook in place with a pliers
and attach the locknut with a 7/16" wrench (Figure 3).
Handle
Handle
Supports
Spray Gun
Hook