Danfoss Devireg 535 Setting Up

Devireg 535
Setting up your Devireg 535 programmable thermostat with
your devimat system
Select the floor
To change the default setting, press
l and use the arrow buttons  to
select your choices. Press l to accept
your choice.
Press  for the next setting.
Maximum floor temperature.
- Tiles on timber based floor = 29°C
- Tiles on concrete based floor = 40°C
- Timber covered floors = 27°C
(parquet etc. - Please check with
floor supplier).
To change this setting, press l and
use the arrow buttons  to select
your choice. Press l to accept your
choice.
Press  for the next setting.
Scale
When selecting Celsius, the display
will show the actual temperature at
the floor sensor.
To change this setting, press l and
use the arrow buttons  to select
your choice.
Press l to accept your choice.
The installation procedure is now finished.
You can use the  for going back or forward through
the settings, otherwise:
Press the installation pinhole to exit
installation mode.
Put the frame and front back on.
Selection of sensor type
Power on the thermostat
With the front off, with
a small screwdriver
or pencil press the
installation button.
sensor
You enter the settings by pressing the
pencil, the display now changes from
temperature to time display.
Setting the time
By pressing the l, the hours starts
flashing - you can now change them
with the .
Press the l again to change the
minutes with the .
To finish, press l then 
Setting the weekday
Mon Tue Wed Thu
By pressing the l, the weekday starts
flashing - you can now change them
with the .
Press the l to accept.
To finish press 
pinhole with a small screw driver,
Fri Sat Sun